MedTrace Logo

Patient Satisfaction and Retention of Upper Complete Denture Base Using Rapid Prototyping Versus a Conventional One

NCT03354715 · Status: UNKNOWN · Phase: NA · Type: INTERVENTIONAL · Enrollment: 16

Last updated 2018-06-12

No results posted yet for this study

Summary

Comparing patient satisfaction and retention of upper complete denture fabricated using two different denture base materials, the first fabricated using rapid prototyping method while the second is following conventional methods.

Conditions

  • Complete Denture

Interventions

DEVICE

Rapid prototyping Denture base

The introduction of rapid prototyping (RP)Stereo lithography (SLA) technology, which mainly depends on addition of layers of materials which would be polymerized using a light curing unit. It consists of a bath of photo polymerized liquid and ultraviolet unit for curing these layers, that would bond to each other till forming the full object. SLA has many advantage as high accuracy, high mechanical strength, smooth surface finish with close tolerance and fine details printing, but it has some limitation as it is only limited Material, in addition to the high material and equipment cost.

DEVICE

Heat Cured Conventional Complete Denture

it is the main treatment for most of completely edentoulous Cases

Sponsors & Collaborators

  • Cairo University

    lead OTHER

Study Design

Allocation
RANDOMIZED
Purpose
SUPPORTIVE_CARE
Masking
SINGLE
Model
PARALLEL

Eligibility

Min Age
40 Years
Max Age
70 Years
Sex
ALL
Healthy Volunteers
No

Timeline & Regulatory

Start
2017-04-20
Primary Completion
2018-07-01
Completion
2018-12-01

Countries

  • Egypt

Study Locations

More Related Trials

Read the full study record

This page highlights key information. For complete eligibility criteria, study locations, investigator contacts, and the full protocol, visit the original record on ClinicalTrials.gov.

View NCT03354715 on ClinicalTrials.gov