MedTrace Logo

Validity and Reliability of Autocad Software Assessment of JPS in PFPS

NCT03685812 · Status: COMPLETED · Type: OBSERVATIONAL · Enrollment: 38

Last updated 2019-04-01

No results posted yet for this study

Summary

The overall aim of the study is to assess the reliability and validity of Autocad software to measure JPS in PFPS, especially:

1. To assess the intra-tester and between day reliability of measurement of JPS using Autocad software.
2. To assess the validity of these measurements against those found during an IKD.

Conditions

  • Patellofemoral Pain Syndrome

Interventions

DIAGNOSTIC_TEST

Autocad software

The participants will be prepared for image-capture data collection by putting four squared markers on leg and thigh.Each subject will extend his/her leg and make two angles from the resting position (90º) to the full extension, photos will be taken. The tested leg passively moved by the researcher through 20° to 60° of knee extension, the participant will be instructed to actively move that leg to the target angle and hold it in this position another photograph will be taken. The angles will be measured using the AutoCAD software. Knee JPS measurements will also be collected using an IKD by same steps

Sponsors & Collaborators

  • Cairo University

    lead OTHER

Principal Investigators

  • karima A Hassan · Cairo University

Eligibility

Min Age
18 Years
Max Age
35 Years
Sex
ALL
Healthy Volunteers
No

Timeline & Regulatory

Start
2018-09-25
Primary Completion
2019-02-01
Completion
2019-02-01

Countries

  • Egypt

Study Locations

More Related Trials

Read the full study record

This page highlights key information. For complete eligibility criteria, study locations, investigator contacts, and the full protocol, visit the original record on ClinicalTrials.gov.

View NCT03685812 on ClinicalTrials.gov