Evaluation of a New Postoperative Dressing After Hallux Valgus Surgery

Summary

Hallux valgus, commonly known as a bunion, is a condition where the big toe deviates toward the other toes, often causing pain, difficulty with footwear, and decreased quality of life. Surgery can correct the alignment of the big toe, but during recovery the toes must be supported in the correct position so that the improvement is maintained. After this surgery, a spacer is usually placed between the big toe and the second toe for several weeks while the soft tissues heal.

Standard spacers made of folded gauze are not custom-shaped to each patient's foot, which may lead to discomfort, skin irritation, or misalignment of the other toes. To address these limitations, a new custom-made spacer has been developed using 3D printing technology. This spacer is individually designed to match each patient's foot shape, with the goal of improving comfort and maintaining proper toe alignment throughout the healing phase.

This clinical study will evaluate whether the custom-made 3D-printed spacer is better tolerated by patients than the traditional folded-gauze spacer and whether it helps maintain the corrected position of the big toe after surgery. The study will include 40 adults undergoing bunion surgery. Participants will be randomly assigned, like drawing lots, to receive either the 3D-printed spacer or the standard gauze spacer. Both spacers are applied externally during surgery and are worn continuously for five weeks as part of routine postoperative care.

Participants will attend follow-up visits at 1 week, 3 weeks, and 5 weeks after surgery. At each visit, comfort, pain, and any skin irritation caused by the spacer will be evaluated. At the final visit, toe alignment will be assessed using routine weight-bearing X-rays and clinical examination. No additional medical procedures or radiation will be required beyond standard care.

The hypothesis of this study is that the custom 3D-printed spacer will be well tolerated and will help maintain better toe alignment compared with the standard folded-gauze spacer. If successful, this personalized approach may improve recovery and patient satisfaction after bunion surgery.

Conditions

• Hallux Valgus

Interventions

DEVICE

Custom 3D-printed toe spacer

A custom-made spacer designed to maintain hallux alignment after bunion surgery. It is produced individually for each participant using 3D-printing technology based on foot measurements. The device is manufactured from thermoplastic polyurethane (TPU), a biocompatible material commonly used for orthopedic applications. The spacer is externally applied between the hallux and second toe immediately following surgery and remains in place continuously for 5 weeks as part of routine postoperative care. The device does not contact the surgical wound, which is covered by a sterile dressing, and does not require any additional medical procedures for application or removal.

DEVICE

Standard folded-gauze toe spacer

Participants receive a standard postoperative toe spacer consisting of folded medical gauze placed between the hallux and second toe immediately after surgery. The spacer is worn continuously for 5 weeks as part of routine care and represents the current standard method used at the study center.

Sponsors & Collaborators

• Centre Assal for Foot Medicine and Surgery SA

  lead OTHER

Study Design

Allocation

RANDOMIZED

Purpose

SUPPORTIVE_CARE

Masking

NONE

Model

PARALLEL

Eligibility

Min Age

18 Years

Sex

ALL

Healthy Volunteers

No

Timeline & Regulatory

Start

2025-12-15

Primary Completion

2026-11-30

Completion

2027-04-15

Countries

• Switzerland

Study Locations