Radiographic and Histological Assessment of Autogenous Onlay Block Versus Cortical Shell on Anterior Maxilla
NCT06450535 · Status: RECRUITING · Phase: NA · Type: INTERVENTIONAL · Enrollment: 16
Last updated 2024-06-10
Summary
Two groups of patient with horizontally deficient anterior maxilla indicated for bone augmentation ,one will be subjected to autogenous onlay bone block from retromolar bone and the other to cortical shell from retromolar bone also.
Conditions
- Alveolar Bone Loss
Interventions
- PROCEDURE
-
Autogenous onlay bone block harvesting from retromolar bone in anterior maxilla
Surgical protocol ( retromolar bone harvesting) After injecting local anesthesia a crestal incision is done, from a point on the occlusal surface along the external oblique ridge and extending anteriorly and inferiorly through the buccal mucosa, parallel to the gingival margin of the mandibular molars. The subperiosteal dissection extend to expose the ascending ramus and the retromolar region With the aid of surgical carbide burs, two proximal vertical cuts penetrating the cortex of the external oblique ridge. The depth of penetration of the posterior cut did not exceed 2.5 mm to avoid injury to the inferior alveolar nerve. By using microsaw , an inferior cut of 3.2 mm in depth joining the anterior and posterior vertical cuts was done. Small perforations of 3-4 mm in depth were performed on the superior aspect of the external oblique ridge using 1 mm drill bur. Finally, the block was sheared off using a chisel.
- PROCEDURE
-
Autogenous cortical shell technique from retromolar bone in anterior maxilla
The harvested cortical plate was then split longitudinally in two parts using a microsaw, and thinned with the bone scraper to achieve a plate of 1 mm thickness. The plate was fixed at a distance from the residual ridge with 2 screws. Autogenous bone particles, collected with the bone scraper, were tightly packed into the gap between the plate and the recipient site.
Sponsors & Collaborators
-
Cairo University
lead OTHER
Principal Investigators
-
mohamed atef, PhD · faculty of oral and dental medicine,cairo university
Study Design
- Allocation
- RANDOMIZED
- Purpose
- TREATMENT
- Masking
- SINGLE
- Model
- PARALLEL
Eligibility
- Min Age
- 20 Years
- Max Age
- 60 Years
- Sex
- ALL
- Healthy Volunteers
- No
Timeline & Regulatory
- Start
- 2024-07-01
- Primary Completion
- 2025-12-01
- Completion
- 2025-12-01
Countries
- Egypt
More Related Trials
-
Ridge Splitting Using Autogenous Bone Wedge Versus the Conventional Intercortical Augmentation Technique in Horizontally Deficient Anterior Maxilla
NCT06529653 ·Status: RECRUITING ·Phase: NA
-
Radiographic Evaluation of Bone Height Gain With Dental Implant Placed Simultaneously With Closed Sinus Lifting Using Hydraulic Lift Technique Versus Summers' Osteotome Technique in Posterior Edentulous Maxilla (RCT)
NCT04648514 ·Status: UNKNOWN ·Phase: NA
-
Vertical Augmentation Using Onlay Versus Inlay Autogenous Graft With Simultaneous Implant Placement.
NCT03052387 ·Status: UNKNOWN ·Phase: NA
-
Horizontal Anterior Maxillary Ridge Augmentation Using Autogenous Ring Block Grafts Combined With Particulate Xenogeneic Bone Versus Biphasic Beta-tri-calcium Phosphate Sulphate EthOss Graft: A Clinical Study
NCT07212985 ·Status: COMPLETED ·Phase: NA
-
Reconstruction of Atrophic Maxillary Ridges Using Mandibular Blocks With and Without Coverage Using Collagen Membrane
NCT04462575 ·Status: COMPLETED ·Phase: NA
-
Ridge Augmentation in Posterior Mandible Using Tunneling Technique With Amix of Autogenous Bone and Xenograft With and Without Collagen Membrane
NCT03712631 ·Status: UNKNOWN ·Phase: NA
-
Radiographic Assessment of Bone Gain Following Sinus Lifting With Simultaneous Implant Placement Using Crestal Approach With Membrane Control Technique for Bone Augmentation of Atrophied Maxillary Posterior Ridge
NCT06446687 ·Status: NOT_YET_RECRUITING ·Phase: NA
-
Autogenous Grafts for Anterior Maxillary Horizontal Ridge Augmentation
NCT06206577 ·Status: COMPLETED ·Phase: NA
-
Histomorphometric and Radiographic Evaluation of Bone Following Maxillary Sinus Augmentation
NCT06700772 ·Status: RECRUITING ·Phase: PHASE1
-
Assessment of Bone Quality and Quantity for Three Dimensional Bone Augmentation for Maxilla Using Patient Specific Titanium Meshes Loaded With Bone Marrow Aspirate Mixed With Xenograft Versus Xenograft Mixed With Autografts Only: a Randomized Clinical Trial
NCT05400044 ·Status: UNKNOWN ·Phase: NA
-
Reconstruction of Deficient Atrophic Ridges Using Guide Bone Regeneration Technique
NCT06746935 ·Status: RECRUITING ·Phase: NA
-
Computer Guided Versus Free Hand Horizontal Ridge Augmentation in Anterior Mandible.
NCT05556330 ·Status: UNKNOWN ·Phase: NA
-
Cortical Bone Plate Versus Cortico-cancellous Block Graft
NCT04567966 ·Status: COMPLETED ·Phase: NA
-
Assessment of Bone Gain Following Composite Graft Rehabilitation of Horizontal Maxilla Atrophy With Sausage Technique Utilizing (Pericardial) Collagen Membrane
NCT06831214 ·Status: RECRUITING ·Phase: NA
-
Using the Roots of a Non Restorable Wisdom Tooth as a Block for Augmentation of Localized Defects
NCT04266652 ·Status: UNKNOWN ·Phase: PHASE4
-
L- Shape Symphyseal Autogenous Bone Block for Alveolar Ridge Augmentation in Anterior Maxilla and Mandible
NCT05844540 ·Status: COMPLETED ·Phase: NA
-
Grafting of the Peri-implant Bony Defects Around Immediate Implants Using Xenogenic Versus Alloplastic Sticky Grafts: Randomized Controlled Clinical Trial
NCT06653868 ·Status: RECRUITING ·Phase: NA
-
Radiographic Assessment Of The Accuracy Of 3D Ridge Augmentation In Anterior Mandible Using Computer Guided Autogenous Cortical Shell Technique Versus Free Hand Technique
NCT06691516 ·Status: NOT_YET_RECRUITING ·Phase: NA
-
Patient Satisfaction and Bone Gain Following Autogenous Particulate Sticky Bone Preparation With Xenograft Versus Without Xenograft for Grafting of Maxillary Anterior Knife Edge Ridge in Partially Edentulous Patients for Implant Placement
NCT03556111 ·Status: UNKNOWN ·Phase: NA
-
Radiographic and Histomorphometric Assessment for Maxillary Sinus Floor Elevation and Augmentation Using A Mixture of 1:1 Autogenous Bone With Deproteinized Bovine Bone Particulate Versus Deproteinized Bovine Bone Particulate
NCT07177495 ·Status: RECRUITING ·Phase: NA
-
Computer-guided vs. Conventional Cortical Shell Technique for Horizontal Augmentation
NCT05311332 ·Status: COMPLETED ·Phase: NA
-
Radiographic Assessment of Guided Cortical Shell Technique for Horizontal Ridge Augmentation
NCT06942013 ·Status: NOT_YET_RECRUITING ·Phase: NA
-
Evaluation of Horizontal Bone Gain in the Lower Posterior Partially Edentulous Patient Comparing the Stabilization of Membranes With and Without Tacs
NCT06257225 ·Status: NOT_YET_RECRUITING ·Phase: NA
-
Radiographic and Histomorphometric Assessment of Anterior Horizontal Maxillary Bone Augmentation Using Autogenous and Bovine Sticky Bone Versus Autogenous and Bovine Bone Shell Technique (Khoury): A Randomized Comparative Clinical Trial
NCT07210385 ·Status: ACTIVE_NOT_RECRUITING ·Phase: NA
-
Anterior Maxilla Augmentation Using Chin Bone Ring With Implant Placement
NCT05620459 ·Status: UNKNOWN ·Phase: NA